Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Kia Soul Base, Automatic TransFACTORY OEM SERVICE PROCEDURE
TCM Terminal Function
WARNING: This page is about a different car, the 2018 Hyundai Accent. However, it is still accessible from the selected car via links, so may be relevant.
| Connector [A] | Connector [K] | ||
|---|---|---|---|
| Pin | Description | Pin | Description |
| A22 | Overdrive clutch control solenoid valve (OD/C_VFS) | K1 | GND (Power) |
| A23 | Line pressure control solenoid (VFS-LINE) | K2 | GND (Power) |
| A26 | ON/OFF solenoid valve B (SS-B) | K3 | VB (Battery voltage) |
| A37 | Sports mode up switch | K4 | GND (Power) |
| A38 | Sports mode select switch | K5 | VB (Battery voltage) |
| A39 | Oil temperature sensor (+) | K59 | CCP CAN HIGH |
| A43 | Underdrive brake control solenoid valve (UD/B_VFS) | K60 | CAN (HIGH) |
| A44 | 35R clutch control solenoid valve (35R/C_VFS) | K68 | Ignition 1 |
| A45 | Torque converter control solenoid (T/CON_VFS) | K76 | CCP CAN LOW |
| A46 | 26 brake control solenoid valve (26/B_VFS) | K77 | CAN (LOW) |
| A58 | Sports mode down switch | ||
| A59 | Oil temperature sensor (-) | ||
| A73 | Inhibitor switch signal "S4" | ||
| A74 | Inhibitor switch signal "S2" | ||
| A75 | Inhibitor switch signal "S3" | ||
| A87 | Solenoid power 1 (A45, A67, A24, A46) | ||
| A88 | Solenoid power 2 (A43, A66, A44, A25) | ||
| A89 | ON/OFF solenoid valve A (SS-A) | ||
| A93 | Shift lock solenoid | ||
| A94 | Inhibitor switch signal "S1" | ||
| A95 | Output speed sensor power | ||
| A96 | Input speed sensor power | ||
| A99 | Input speed sensor signal | ||
| A100 | Output speed sensor signal | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.