2019 Kia Soul !FACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
  2. Remove the air cleaner assembly and air intake hose.

    (Refer to Engine Mechanical System - "AIR CLEANER ")

  3. Remove the engine wiring.
    1. Disconnect the OCV and WGV extension connector (A).
      Fig 1: Locating OCV And WGV Extension Connector
      G12238616Courtesy of KIA MOTORS AMERICA, INC.
    2. Disconnect the ignition coil connector (A).
    3. Disconnect the CMPS connector (B).
    4. Disconnect the FPCV connector (C).
    5. Disconnect the PCSV connector (D).
    6. Remove the engine wiring mounting bolts (E) and then remove the engine wiring harness (F).
    Fig 2: Locating Connectors, Engine Wiring Mounting Bolts And Engine Wiring Harness
    G12238617Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the vacuum pipe mounting bolts (A) and make a gap by moving the bracket.
  5. Disconnect the engine coolant temperature sensor connector (B).
  6. Remove the engine coolant temperature sensor (C).
    Fig 3: Locating Engine Coolant Temperature Sensor, Connector And Vacuum Pipe Mounting Bolts
    G12238618Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.