2019 Kia Sedona EXFACTORY OEM SERVICE PROCEDURE

Section 94 (Audio/Video/Navigation (AVN) System): Troubleshooting: Camera

WARNING: This page is about a different car, the 2020 Kia Sedona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Features/Misdiagnose cases
    Inspection Description
    (1) System features
    1. Camera system features
      1. Change to H/U camera mode at gear R
      2. Steering wheel feature with CAN enabled Camera
      3. Diagnostic Trouble Code (DTC) feature added to CAN enabled camera
      4. Video Format - current: Analog/YG, HI: LVDS applied (New)
      5. Camera power ON (below 35~40km/h, 2015 Q4)
    2. AVM system features
    1. Change to H/U Rear view camera and AVM display at gear R
    2. On gear D, Rear view → Front view change at speed below 10km/h (AVM is ON)
    3. On gear D, Navigation mode change at speed above 10km/h (AVM is ON)
    4. Video format: CVBS, S-VIDEO, Component, LVDS
    (2) Misdiagnose cases
    1. Camera misdiagnose cases
      1. Video quality: Rear view camera have low quality spec (0.3 megapixel), dirt on lens
      2. Bumper showing too much: Camera angle
      3. Blinks on start of ignition: Black curtain process for AVN boot spec
      4. Parking guideline length: Camera location
      5. Blue screen: Possible camera output defect from AVN, AVM (Possible connector, cable defect)
    2. AVM misdiagnose cases
    1. Top view distortion: In-line correction error. Re-correction fixes issue
    2. Broken image pixel: Incomplete correction due to power OFF during correction process
    3. Camera screen defect (Top/Front/Rear/Left/Right): Possible camera defect
  2. Camera issue (Black screen/Blue screen/Noise/Broken)
    Issue Inspection Description
    Camera issue (Black screen/Blue screen/Noise/Broken) (1) Duplicate issue
    • Check gear R
    • Open/close door
    • Test drive to duplicate issue
    G13046700G13046701G13046702Courtesy of KIA MOTORS AMERICA, INC.KIA MOTORS AMERICA, INC.KIA MOTORS AMERICA, INC.
    1. Check gear R

      (Normal: Camera+ Guide line + warning message)

    2. Open/close door test

      (Duplicate issue at angles)

    3. Test drive

    (Drive impact)
    If issue duplicates, follow steps below
    G13046700G13046701G13046702Courtesy of KIA MOTORS AMERICA, INC.KIA MOTORS AMERICA, INC.KIA MOTORS AMERICA, INC.
    Factory Service Tools

    Use the Manual With the Right Hardware

    Pair factory procedures with proven DIY tools so the instructions are easier to execute.

    Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

    Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

    When to See a Mechanic

    Stop DIY work and contact a certified mechanic immediately if any of the following apply:

    • • You smell fuel, burning insulation, or see smoke.
    • • Brakes feel soft, pull hard to one side, or make grinding noises.
    • • The engine overheats, stalls repeatedly, or misfires under load.
    • • You are missing required tools, torque specs, or safe lifting equipment.
    • • You are not confident in the next step or safety outcome.