2019 Kia Rio LXFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Installation

  1. Check that the shift lever is placed in the "N" position.
  2. Install the shift cable retainer (A) by tightening nuts (B).

    Tightening torque: 

    11.8 - 14.7 N.m (1.2 - 1.5 kgf.m, 8.7 - 10.8 lb.ft)

    G12576947Courtesy of KIA MOTORS AMERICA, INC.
  3. Install the cable socket (A).
    G12576948Courtesy of KIA MOTORS AMERICA, INC.
  4. Install the shift cable to the lever pin and then insert the snap pin (A).
    G12576949Courtesy of KIA MOTORS AMERICA, INC.
    NOTE:
    • Install the shift cable after checking the direction of projection to prevent incorrect assembly.
      G12576950Courtesy of KIA MOTORS AMERICA, INC.
    • Mind the installation direction of snap pin and install the snap pin with the hook facing upward.
      G12576951Courtesy of KIA MOTORS AMERICA, INC.
  5. Install the floor console assembly.

    (Refer to Body - " FLOOR CONSOLE ASSEMBLY  ") 

  6. Install the knob (A) by pressing it in the direction of arrow after installing the boots to the console upper cover.
    G12576952Courtesy of KIA MOTORS AMERICA, INC.
  7. Tighten the nut (A) to the specified torque after removing free play by pushing the shift cable (B) in the direction of the arrow.

    Tightening torque: 

    9.8 - 13.7 N.m (1.0 - 1.4 kgf.m, 7.2 - 10.1 lb.ft)

    G12576953Courtesy of KIA MOTORS AMERICA, INC.
    NOTE: The existing shift cable clip must be replaced with new one. (Do not reuse it.)
    G12576954Courtesy of KIA MOTORS AMERICA, INC.
  8. Install the battery and battery tray.

    (Refer to Engine Electrical System - " BATTERY  ") 

  9. Install the air cleaner assembly.

    (Refer to Engine Mechanical System - " AIR CLEANER  ") 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.