Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Kia Optima SX LimitedFACTORY OEM SERVICE PROCEDURE
Repair Procedures: Removal
- Turn the ignition switch off and disconnect the battery (-) terminal.
- Remove the RCV control solenoid valve.
(Refer to "RCV CONTROL SOLENOID VALVE ")
- Remove the purge control solenoid valve.
(Refer to "PURGE CONTROL SOLENOID VALVE ")
- Disconnect the variable charge motion actuator connector (A).
- Remove the variable charge motion actuator mounting bolts (B).
- Remove VCMA rod clip (A) and connection link between flap (B) using screwdriver.
NOTE:
VCMA connection link can be damaged. So, make sure to remove it in a horizontal direction.
Make sure that groove part of the connection link (C) is pointing upward when mounting VCMA.
Make sure that groove part of the connection link (C) is pointing upward when mounting VCMA.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.