2019 Kia Optima EXFACTORY OEM SERVICE PROCEDURE

TCM terminal function

WARNING: This page is about a different variant/trim than selected.
PIN DESCRIPTION

Pin Description Pin Description
1 Solenoid power 1 31 Sports mode down switch
2 Line pressure control solenoid valve 45 Ground
3 Engine clutch control solenoid valve 46 Ground
4 35R clutch control solenoid valve 48 Oil temperature sensor (-)
7 Inhibitor switch signal 1 64 Battery power (B+)
8 Inhibitor switch signal 2 68 ON/OFF solenoid valve (SS-A)
9 Sports mode up switch 69 ON/OFF solenoid valve (SS-B)
22 Solenoid power 2 70 OPU status
23 Underdrive brake control solenoid valve 71 Input speed sensor signal
24 26B control solenoid valve 72 Output speed sensor signal
25 Overdrive clutch control solenoid valve 85 Battery power (B+)
26 PWM Command 92 Oil temperature sensor (+)
28 Inhibitor switch signal 4 93 Input speed sensor power
29 Inhibitor switch signal 3 94 Output speed sensor power
30 Sports mode select switch Β  Β 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.