2019 Kia Optima EXFACTORY OEM SERVICE PROCEDURE

DTC Index

DTC INDEX

DTC Description
DTC P2096  00: Post Catalyst Fuel Trim System too Lean (Bank 1)
DTC P2097  00: Post Catalyst Fuel Trim System too Rich (Bank 1)
DTC P2101  00: Throttle Actuator Control Motor Circuit Range/Performance
DTC P2118  00: Throttle Actuator Control Motor Current Range/Performance
DTC P2119  00: Throttle Actuator Control Throttle Body Range/Performance
DTC P2122  00: Accelerator Position Sensor 1 Signal Circuit Low Input
DTC P2123  00: Accelerator Position Sensor 1 Signal Circuit High Input
DTC P2127  00: Accelerator Position Sensor 2 Signal Circuit Low Input
DTC P2128  00: Accelerator Position Sensor 2 Signal Circuit-High Input
DTC P2138  00: Accelerator Position Sensor 1 & 2 Signal Voltage Correlation
DTC P2147  00: Fuel Injector Group 'A' Supply Voltage Circuit Low
DTC P2148  00: Fuel Injector Group 'A' Supply Voltage Circuit High
DTC P2150  00: Fuel Injector Group 'B' Supply Voltage Circuit Low
DTC P2151  00: Fuel Injector Group 'B' Supply Voltage Circuit High
DTC P2159  00: Vehicle Speed Sensor 'B' Range/Performance (Wheel Speed Sensor)
DTC P2195  00: O2 Sensor Signal Stuck Lean (Bank 1 Sensor 1)
DTC P2196  00: O2 Sensor Signal Stuck Rich (Bank 1 Sensor 1)
DTC P219C  00: Cylinder 1 Air-Fuel Ratio Imbalance
DTC P219D  00: Cylinder 2 Air-Fuel Ratio Imbalance
DTC P219E  00: Cylinder 3 Air-Fuel Ratio Imbalance
DTC P219F  00: Cylinder 4 Air-Fuel Ratio Imbalance
DTC P2227  00: Barometric Pressure Circuit Range/Performance
DTC P2228  00: Barometric Pressure Circuit Low Input
DTC P2229  00: Barometric Pressure Circuit High Input
DTC P2237  00: O2 Sensor Pumping Current Circuit/Open (Bank 1 Sensor 1)
DTC P2243  00: O2 Sensor Reference Voltage Circuit/Open (Bank 1 Sensor 1)
DTC P2251  00: O2 Sensor Reference Ground Circuit/Open (Bank 1 Sensor 1)
DTC P2270  00: O2 Sensor Signal Stuck Lean (Bank 1 Sensor 2)
DTC P2271  00: O2 Sensor Signal Stuck Rich (Bank 1 Sensor 2)
DTC P2297  00: O2 Sensor Out of Range During Deceleration - (Bank 1 Sensor 1)
DTC P2401  00: EVAP System Leak Detection Pump Control Circuit Low
DTC P2402  00: EVAP System Leak Detection Pump Control Circuit High
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.