Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Kia Niro TouringFACTORY OEM SERVICE PROCEDURE
ECM Neutral Mode Procedure (With Smart key)
WARNING: This page is about a different variant/trim than selected.
- After replacing the ECM of the vehicle with the smart key system (button start), the following procedure must be performed.
[If installing a used ECM]
- Perform "ECM Neutral Mode" procedure using KDS/GDS.
(Refer to " REPAIR PROCEDURES ")
- After finishing "ECM Neutral Mode", turn IGN ON then OFF using the smart key or start button. Then the ECM learns information on the smart key automatically.
(Refer to " REPAIR PROCEDURES ")
[If installing a new ECM]
- Turn IGN ON then OFF using the smart key or start button. Then the ECM learns information on the smart key automatically.
(Refer to " REPAIR PROCEDURES ")
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
