Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2019 Kia Niro FEFACTORY OEM SERVICE PROCEDURE

Schematic Diagrams: Removal

Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
Disconnect the TCM connectors (A).
Disconnect the ECM connectors (B).

Courtesy of KIA MOTORS AMERICA, INC.
Remove the ECM & TCM bracket (B) after loosening the mounting nuts (A).
ECM & TCM bracket mounting nut:

9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)

Courtesy of KIA MOTORS AMERICA, INC.
Remove the ECM (B) after loosening the mounting nuts (A) from the ECM & TCM bracket.

Courtesy of KIA MOTORS AMERICA, INC.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.