2019 Kia Forte FE, Standard TransFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Remove the knob (A) by pulling it in the direction of upward after removing the boots from the console upper cover.
    G12830426Courtesy of KIA MOTORS AMERICA, INC.
  2. Remove the floor console assembly.

    (Refer to Body - "Β FLOOR CONSOLE ASSEMBLYΒ  ")Β 

  3. Remove the select cable.
    1. Remove the snap pin (A).
      G12830427Courtesy of KIA MOTORS AMERICA, INC.
    2. Remove the select cable (A) from the shift lever.
      G12830428Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the shift cable.
    1. Remove the snap pin (A) in the direction of the arrow.
      G12830429Courtesy of KIA MOTORS AMERICA, INC.
    2. Remove the shift cable (A) from the shift lever.
      G12830430Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the shift lever assembly (A) after loosening the mounting bolts.

    Tightening torque:Β 

    8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb ft)

    G12830431Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.