2019 Kia Forte EXFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Move the shift lever to 4th gear.
  2. Remove the air cleaner assembly and air duct.

    (Refer to Engine Mechanical System - " AIR CLEANER  ") 

  3. Remove the battery and battery tray.

    (Refer to Engine Electrical System - " BATTERY  ") 

  4. Remove the control cable from the control shaft after removing the snap pins (A).
  5. Remove the shift cable (B) and select cable (C).
    G12830433Courtesy of KIA MOTORS AMERICA, INC.
  6. Remove the knob (A) by pulling it in the direction of upward after removing the boots from the console upper cover.
    G12830434Courtesy of KIA MOTORS AMERICA, INC.
  7. Remove the floor console assembly.

    (Refer to Body - " FLOOR CONSOLE ASSEMBLY  ") 

  8. Remove the select cable.
    1. Remove the snap pin (A).
      G12830435Courtesy of KIA MOTORS AMERICA, INC.
    2. Remove the select cable (A) from the shift lever.
      G12830436Courtesy of KIA MOTORS AMERICA, INC.
  9. Remove the shift cable.
    1. Remove the snap pin (A) in the direction of the arrow.
      G12830437Courtesy of KIA MOTORS AMERICA, INC.
    2. Remove the shift cable (A) from the shift lever.
      G12830438Courtesy of KIA MOTORS AMERICA, INC.
  10. Remove the shift cable retainer (A) after loosening the nuts (B). Then, remove the shift cable by pulling it toward the vehicle interior.
    G12830439Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.