2019 Kia Forte EXFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Replacement

WARNING: This page is about a different car, the 2019 Kia Soul EV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the shift lever knob & boots assembly (A) by Pulling in the upside.
    G12825951Courtesy of KIA MOTORS AMERICA, INC.
  2. Remove the floor console assembly.

    (Refer to "FLOOR CONSOLE ASSEMBLY ")

  3. Disconnect the shift lever switch connector (A).
    G12825952Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the wiring fastener (A) from the shift lever assembly.
    G12825953Courtesy of KIA MOTORS AMERICA, INC.
  5. Separate the lever pin (B) and then remove the shift cable (A).
    G12825954Courtesy of KIA MOTORS AMERICA, INC.
  6. Remove the shift lever assembly (B) by loosening the bolts (A).

    Tightening torque:Β 

    1.0 ~ 1.4 kgf.m

    G12825955Courtesy of KIA MOTORS AMERICA, INC.
  7. Install in the reverse order of removal.
    NOTE: When installing, set room side shift lever and T/M side lever to "N" position.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.