2019 Kia Forte EXFACTORY OEM SERVICE PROCEDURE

Neutralization Status Check

  1. Connect the cable of KDS to the data link connector in driver side crash pad lower panel.
  2. After IG ON, select the "Neutralization mode".
    G12832749Courtesy of KIA MOTORS AMERICA, INC.
    G12832750Courtesy of KIA MOTORS AMERICA, INC.
    G12832751Courtesy of KIA MOTORS AMERICA, INC.
    G12832752Courtesy of KIA MOTORS AMERICA, INC.
    G12832753Courtesy of KIA MOTORS AMERICA, INC.
    G12832754Courtesy of KIA MOTORS AMERICA, INC.
    G12832755Courtesy of KIA MOTORS AMERICA, INC.
    G12832756Courtesy of KIA MOTORS AMERICA, INC.
    G12832757Courtesy of KIA MOTORS AMERICA, INC.
    G12832758Courtesy of KIA MOTORS AMERICA, INC.
    G12832759Courtesy of KIA MOTORS AMERICA, INC.
    G12832760Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.