2018 Kia Sedona LXFACTORY OEM SERVICE PROCEDURE

[Component Inspection]

  1. Check the spark plug for any damage on its thread and insulator.

    If there is damage, replace the spark plug.

  2. Check the electrode. Measure the insulation resistance with an ohmmeter.

    If the resistance is less than the specified value, adjust the electrode gap.

    Specification: 10 MΩ or more

    Fig 1: Measure Insulation Resistance With Ohmmeter
    G12273557Courtesy of KIA MOTORS AMERICA, INC.
  3. Check the spark plug electrode gap.

    If the gap is greater than the maximum, replace the spark plug.

    Specification: 1.0 ~ 1.1 mm (0.0394 ~ 0.0433 in.)

    NOTE:
    • When adjusting the gap of a new spark plug, bend only the base of the ground electrode. Do not touch the tip. Never attempt to adjust the gap on a used plug.
    Fig 2: Checking Spark Plug Electrode Gap
    G12273558Courtesy of KIA MOTORS AMERICA, INC.

Cleaning 

The combustion temporarily becomes unstable, due to the aged fuel and the carbon deposits accumulated on the spark plug(s) after long-term storage.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.