2018 Kia Sedona EXFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

WARNING: This page is about a different car, the 2017 Kia Sedona. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Take care not to scratch the crash pad and related parts.
  1. Disconnect the negative (-) battery terminal.
  2. Remove the glove box housing.

    (Refer to Body - "GLOVE BOX HOUSING ")

  3. Remove the multi box assembly (A) after loosening the screw.
    Fig 1: Locating Multi Box Assembly Screw
    G12274953Courtesy of KIA MOTORS AMERICA, INC.
  4. Disconnect the blower motor connector (A) and clip (B).
    Fig 2: Locating Blower Motor Connector & Clip
    G12274954Courtesy of KIA MOTORS AMERICA, INC.
  5. Disconnect the BCM & Receiver unit connectors (A).
    Fig 3: Locating BCM & Receiver Unit Connectors
    G12274955Courtesy of KIA MOTORS AMERICA, INC.
  6. Disconnect the mounting clip (A) and then remove the receiver (B) after loosening the nut.
    Fig 4: Locating Mounting Clip
    G12274956Courtesy of KIA MOTORS AMERICA, INC.
  7. Remove the BCM & Receiver unit (A) after loosening the nuts.
    Fig 5: Locating BCM & Receiver Unit With Nuts
    G12274957Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.