Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2018 Kia Sedona EXFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Inspection

WARNING: This page is about a different car, the 2018 Kia Cadenza. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative (-) battery terminal.
Remove the overhead console lamp.
(Refer to Lighting System - "OVERHEAD CONSOLE LAMP ")
Disconnect the overhead console lamp connector (A).

Fig 1: Locating Overhead Console Lamp Connector
Courtesy of KIA MOTORS AMERICA, INC.
Remove the overhead console lamp cover (A) after loosening the mounting screws.

Fig 2: Locating Overhead Console Lamp Cover With Mounting Screws
Courtesy of KIA MOTORS AMERICA, INC.
Remove the hands free Mic (A) after loosening the mounting screws.

Fig 3: Locating Hands Free Mic With Mounting Screws
Courtesy of KIA MOTORS AMERICA, INC.
Check the continuity between terminals.

Fig 4: MIC With Connector End View
Courtesy of KIA MOTORS AMERICA, INC.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.