2018 Kia Optima SXFACTORY OEM SERVICE PROCEDURE

TCM Terminal Input/Output Signal

Pin Description Condition Input/output value
Type -
1 Solenoid supply power 1 On Power 0V/Battery voltage
Off 9V < Battery voltage
2 Line pressure control solenoid valve - Output 0V/Battery voltage
Low 9V < Battery voltage
3 Torque converter control solenoid valve - Output 0V/Battery voltage
Low 9V < Battery voltage
4 35R clutch control solenoid valve - Output 0V/Battery voltage
Low 9V < Battery voltage
7 Inhibitor switch signal "S1" High Input 0V/Battery voltage
Low 9V < Battery voltage
8 Inhibitor switch signal "S2" High Input 0V/Battery voltage
Low 9V < Battery voltage
9 Manual mode up switch Up On Input 0V/Battery voltage
Other 9V < Battery voltage
22 Solenoid supply power 2 On Power 0V/Battery voltage
Off 9V < Battery voltage
23 Underdrive brake control solenoid valve Low Output 0V/Battery voltage
9V < Battery voltage
Power supply: V_
24 26 brake control solenoid valve Low Output 0V/Battery voltage
9V < Battery voltage
Power supply: V_
25 Overdrive clutch control solenoid valve Low Output 0V/Battery voltage
9V < Battery voltage
Power supply: V_
28 Inhibitor switch signal "S4" High Input 0V/Battery voltage
Low 9V < Battery voltage
29 Inhibitor switch signal "S3" High Input 0V/Battery voltage
Low 9V < Battery voltage
30 Manual mode select switch Sports mode Input 0V/Battery voltage
Other 9V < Battery voltage
31 Manual mode down switch Down On Input 0V/Battery voltage
Other 9V < Battery voltage
45 Ground - Ground -
46 Ground - Ground -
48 Oil temperature sensor (-) - Ground -
64 Battery voltage (B+) On Power 0V/Battery voltage
Off 9V < Battery voltage
68 ON/OFF solenoid valve A (SS-A) High Output 0V/Battery voltage
Low 9V < Battery voltage
69 ON/OFF solenoid valve B (SS-B) High Output 0V/Battery voltage
Low 9V < Battery voltage
71 Input speed sensor signal High Input -
Low
72 Output speed sensor signal High Input -
Low
85 Battery voltage (B+) On Power 0V/Battery voltage
Off 9V < Battery voltage
92 Oil temperature sensor (+) On Input -
Off
93 Input speed sensor power On Power -
Off
94 Output speed sensor power On Power -
Off
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.