Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Kia Optima SXFACTORY OEM SERVICE PROCEDURE
Components And Components Location: Components
Connector Pin Information
| No. | Connector A | Connector B | Connector C |
|---|---|---|---|
| 1 | - | Power 2_GND | - |
| 2 | AT: "P" signal input MT: Clutch switch signal input | WPC Mute_output | SSB LED (IGN) |
| 3 | Brake switch_input | - | SSB LED (ACC) |
| 4 | Start signal feedback_input | - | - |
| 5 | - | Battery (+)_signal | Passenger door antenna_GND |
| 6 | - | Power 1_GND | Driver side door antenna_GND |
| 7 | - | - | Rear antenna_GND |
| 8 | - | - | Bumper antenna_GND |
| 9 | - | - | Interior antenna 2_GND |
| 10 | - | Battery (+)_power | Interior antenna 1_GND |
| 11 | - | - | Immobilizer antenna_GND |
| 12 | - | - | - |
| 13 | Wheel speed sensor_input | - | Exterior buzzer |
| 14 | - | - | IGN1 relay_output |
| 15 | RPM_Input | - | IGN2 relay_output |
| 16 | IGN1 | - | ACC relay_output |
| 17 | ACC signal_input | - | Passenger door antenna_Power |
| 18 | IGN2 | - | Driver side door antenna_Power |
| 19 | B-CAN (Low) | - | Rear antenna_Power |
| 20 | B-CAN (High) | - | Bumper antenna_Power |
| 21 | C-CAN (High) | - | Interior antenna 2_Power |
| 22 | C-CAN (Low) | - | Interior antenna 1_Power |
| 23 | SSB switch2 signal_input | - | Immobilizer antenna_Power |
| 24 | Passenger door switch signal_input | - | - |
| 25 | Driver side door switch signal_input | - | - |
| 26 | SSB switch1 signal_input | - | |
| 27 | - | - | |
| 28 | EMS communication | - | |
| 29 | - | - | |
| 30 | Starter relay_output | - | |
| 31 | SSB Illumination (+) | - | |
| 32 | SSB Illumination (-) | - |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
