2018 Kia Optima Plug-In Hybrid EXFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal: Notes

NOTE: If working with Diagnostic Trouble Code (DTC) P1744 (engine clutch malfunction) requiring replacement of drive motor is indicated, replace motor and transaxle at as a complete unit.
  1. Remove the automatic transaxle.

    (Refer to Automatic Transaxle System - "Β AUTOMATIC TRANSAXLEΒ  ")Β 

  2. Remove the motor assembly mounting bolts.
    G12355458Courtesy of KIA MOTORS AMERICA, INC.
  3. Install the motor removal/installation guide (09450-3D200).
    G12355459Courtesy of KIA MOTORS AMERICA, INC.
  4. After installing the motor removal/installation jig (09365-3D630), separate the motor assembly from automatic transaxle by tightening the bolts (A).
    G12355460Courtesy of KIA MOTORS AMERICA, INC.
    NOTE: Tighten the bolts (A) in turns.
  5. By using a jack, lift off the motor assembly (A) from the automatic transaxle (B).
    G12355461Courtesy of KIA MOTORS AMERICA, INC.
    NOTE:
    • Keep foreign substances away from the motor coil part.
    • Be careful not to touch ground with motor coil part.
    • Be careful not to impact the motor assembly as it may get damaged.
  6. Remove the spacer (A).
    G12355462Courtesy of KIA MOTORS AMERICA, INC.
  7. After removing the snap ring (A), remove the engine clutch assembly (B).
G12355463Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.