2018 Kia Niro Plug-In Hybrid EXFACTORY OEM SERVICE PROCEDURE

Components And Components Location: Components

WARNING: This page is about a different car, the 2018 Hyundai Ioniq. However, it is still accessible from the selected car via links, so may be relevant.
G12730181Courtesy of HYUNDAI MOTOR AMERICA
NO Connector A Connector B Connector C Connector D
1 - - Wiper low relay -
2 - Steering heated switch Auto light ground IGN 1
3 Rear left seat belt indicator - PAS ON Indicator IG2 Steering heated power 1
4 Passenger seat belt indicator - Steering heated indicator IG2 Steering heated power 2
5 Rear center seat belt indicator Light switch - IG2 Steering heated power output
6 Rear right seat belt indicator - - Room lamp
7 - - Crash signal Ground
8 - PAS Input Auto light sensor -
9 Mirror unfolding relay - NTC Sensor -
10 - Sunroof open switch Head lamp switch (High) Power
11 - PAS ON Switch - -
12 - Multifunction switch ground Wiper int vol relay -
13 - - Front wiper switch RPAS Power
14 - - foglamp switch FPAS Power
15 - - Wiper relay (High) Ground signal
16 - - Auto light (Power) Β 
17 Security indicator - Sunroof enable (High)
18 Pocket lamp output - -
19 Safety power window down (Low) C-Can (Low) -
20 - C-Can (High) -
21 - B-CAN (Low) Front wiper low backup switch
22 - B-CAN (High) NTC Ground
23 Mirror folding relay output - IGN 2
24 - Rain sensor_LIN ACC
25 Β  PAS_LIN -
26 - Front wiper washer switch
27 - Blade position
28 Defogger switch Brake switch
29 Rain sensor option_input Β 
30 -
31 Front door open switch
32 Rear door open switch
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.