Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Kia Forte EXFACTORY OEM SERVICE PROCEDURE
Repair Procedures: Removal
WARNING: This page is about a different car, the 2017 Kia Niro. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Be careful not to scratch the center fascia upper panel and related parts.
- Wrap the protective tape on the tool to disassemble with the screwdriver or remover.
- Take caution when keeping and handling during disassembly/assembly as it is easily contaminated by lubricant and oil.
- Disconnect the negative (-) battery terminal.
- Remove the center fascia upper panel.
(Refer to Body - "CENTER FASCIA PANEL ")
- Remove the AVN head unit (A) after loosening the mounting screws.
- Remove the AVN head unit after disconnecting the connectors and antenna cable (A).
- Disconnect the hazard switch connector (A).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.