Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Kia Soul EV BaseFACTORY OEM SERVICE PROCEDURE
Repair Procedures: Replacement
- Disconnect the battery negative cable from the battery and then wait for at least 30 seconds.
- Turn the steering wheel so that the front wheels are facing straight ahead.
- Remove the airbag module.
(Refer to Restraint - "DRIVER AIRBAG (DAB) MODULE AND CLOCK SPRING ")
- Disconnect the connector & lock nut (A) and then remove the steering wheel using the special service tool (09561-11001).
Tightening torque:Β
39.2 ~ 49.0N-m (4.0 ~ 5.0 kgf-m, 28.9 ~ 36.2lb-ft)
CAUTION:- Do not use a hammer when removing the steering wheel as it may damage the steering column.
- Do not reuse lock nuts.
- Lock nuts must be replaced with new ones when assembling. (SEAL-LOCK has been processed)
- Install in the reverse order of removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
