2017 Kia Soul EV BaseFACTORY OEM SERVICE PROCEDURE

Front Door Lock Module Inspection

  1. Remove the front door trim.

    (Refer to Body - "FRONT DOOR TRIM ")

  2. Remove the front door module.

    (Refer to Body - "FRONT DOOR MODULE ")

  3. Disconnect the connectors from the actuator.
    Fig 1: Front Door Lock Module Connector Terminals
    G11934798Courtesy of KIA MOTORS AMERICA, INC.
  4. Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
    Fig 2: Front Door Lock Module Circuit Diagram
    G11934799Courtesy of KIA MOTORS AMERICA, INC.

    [Central Lock]Β 

    Fig 3: Front Door Lock Module Terminal Continuity Chart - Central Lock
    G11934800Courtesy of KIA MOTORS AMERICA, INC.
  5. Check for continuity between the terminals in each switch position according to the table.
    Fig 4: Front Door Lock Module Terminal Continuity Chart - Central Lock
    G11934801Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.