2017 Kia Soul Base, Automatic TransFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Remove the knob & boots (A) by pulling it in the direction of arrow after removing the boots from the console upper cover.
    Fig 1: Removing Knob & Boots
    G12227699Courtesy of KIA MOTORS AMERICA, INC.
  2. Remove the floor console assembly.

    (Refer to Body - "FLOOR CONSOLE ")

  3. Remove the rear heating joint duct (A).
    Fig 2: Locating Rear Heating Joint Duct
    G12227700Courtesy of KIA MOTORS AMERICA, INC.
  4. Disconnect the shift lever main connector.
    Fig 3: Locating Shift Lever Main Connector
    G12227701Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the wiring (A) from the shift lever assembly.
    Fig 4: Locating Shift Lever Assembly Wiring
    G12227702Courtesy of KIA MOTORS AMERICA, INC.
  6. Remove the shift cable (A) from the shift lever assembly.
    Fig 5: Removing Shift Cable From Shift Lever Assembly
    G12227703Courtesy of KIA MOTORS AMERICA, INC.
  7. Remove the shift lever assembly (A) by removing the bolts.

    Tightening torque  :

    9.8 - 14.7 N.m (1.0 - 1.4 kgf.m, 7.2 - 10.8 lb.ft)

    Fig 6: Locating Shift Lever Assembly With Bolts
    G12227704Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.