2017 Kia Soul Base, Automatic TransFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Shift the gear to "N".
  2. Remove the air cleaner assembly.

    (Refer to Engine Mechanical System - "AIR CLEANER ")

  3. Disconnect the inhibitor switch connector (A) and loosen the shift cable mounting nut (B).
    Fig 1: Locating Inhibitor Switch Connector And Shift Cable Mounting Nut
    G12227688Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the manual control lever (B) and the washer after removing a nut (A).
    Fig 2: Locating Manual Control Lever And Nut
    G12227689Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the inhibitor switch (A) after loosening the bolts (B).
    Fig 3: Locating Inhibitor Switch And Bolts
    G12227690Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.