Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Kia Soul Base, Automatic TransFACTORY OEM SERVICE PROCEDURE
Automatic Transaxle System DTCS: 1.6L
AUTOMATIC TRANSAXLE SYSTEM DTC IDENTIFICATION
| DTC | Description |
|---|---|
| DTC P0601 | 00: Internal Control Module Memory Check Sum Error |
| DTC P0705 | 00: Transmission Range Sensor Circuit Malfunction |
| DTC P0706 | 00: Transmission Range Sensor Circuit Range/Performance |
| DTC P0711 | 00: Transmission Fluid Temperature Sensor 'A' Circuit Range/Performance |
| DTC P0712 | 00: Transmission Fluid Temperature Sensor 'A' Circuit Low Input |
| DTC P0713 | 00: Transmission Fluid Temperature Sensor 'A' Circuit High Input |
| DTC P0717 | 00: Input/Turbine Speed Sensor 'A' Circuit No Signal |
| DTC P0721 | 00: Output Speed Sensor Circuit Range/Performance |
| DTC P0722 | 00: Output Speed Sensor Circuit No Signal |
| DTC P0729 | 00: Gear 6 Incorrect Ratio |
| DTC P0731 | 00: Gear 1 Incorrect Ratio |
| DTC P0732 | 00: Gear 2 Incorrect Ratio |
| DTC P0733 | 00: Gear 3 Incorrect Ratio |
| DTC P0734 | 00: Gear 4 Incorrect Ratio |
| DTC P0735 | 00: Gear 5 Incorrect Ratio |
| DTC P0741 | 00: Torque Converter Clutch Circuit Performance or Stuck Off |
| DTC P0743 | 00: Torque Converter Clutch Circuit Electrical |
| DTC P0748 | 00: Pressure Control Solenoid Valve(VFS) 'A' Electrical |
| DTC P0753 | 00: Shift Control Solenoid Valve 'A' Electrical (UD/B) |
| DTC P0758 | 00: Shift Control Solenoid Valve 'B' Electrical (2-6/B) |
| DTC P0763 | 00: Shift Control Solenoid Valve 'C' Electrical (35R/C) |
| DTC P0768 | 00: Shift Control Solenoid Valve 'D' Electrical (OD/C) |
| DTC P0773 | 00: Shift Control Solenoid Valve 'E' Electrical (SS-A) |
| DTC P0880 | 00: TCM Power Signal Error Open/Short (GND) |
| DTC P0955 | 00: Auto Shift Manual Mode Circuit |
| DTC P1602 | 00: CVT No Learning & No EOL Data |
| DTC U0001 | 00: High Speed CAN Communication Bus off |
| DTC U0100 | 00: CAN Timeout (EMS) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.