2017 Kia Sorento LFACTORY OEM SERVICE PROCEDURE

TCM Terminal Function

CONNECTOR PIN DESCRIPTION (A)

Pin Description - -
1 Solenoid supply power 1 31 Manual mode down switch
2 Line pressure control solenoid valve 45 Ground (Power)
3 Torque converter control solenoid valve 46 Ground (Power)
4 35R clutch control solenoid valve 48 Oil temperature sensor (-)
7 Inhibitor switch signal "S1" 64 Battery voltage (B+)
8 Inhibitor switch signal "S2" 68 ON/OFF solenoid valve A (SS-A)
9 Manual mode up switch 69 ON/OFF solenoid valve B (SS-B)
22 Solenoid supply power 2 71 Input speed sensor signal
23 Underdrive brake control solenoid valve 72 Output speed sensor signal
24 26 brake control solenoid valve 85 Battery voltage (B+)
25 Overdrive clutch control solenoid valve 92 Oil temperature sensor (+)
28 Inhibitor switch signal "S4" 93 Input speed sensor power
29 Inhibitor switch signal "S3" 94 Output speed sensor power
30 Manual mode select switch - -
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.