Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2017 Kia Sedona LFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

Move the shift lever to "N" range.
Disconnect the battery negative (-) cable.
Remove the knob (A) and boots (B) by pulling them in the direction of the arrow after separating the boots from the console upper cover.

Fig 1: Removing Knob And Boots
Courtesy of KIA MOTORS AMERICA, INC.
Remove the floor console assembly.
(Refer to Body - "CONSOLE ")
Disconnect the main connector (A).

Fig 2: Locating Main Connector
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the wiring from the shift lever.

Fig 3: Shift Lever Wiring
Courtesy of KIA MOTORS AMERICA, INC.
Remove the shift cable (A) from the shift lever.

Fig 4: Removing Shift Cable
Courtesy of KIA MOTORS AMERICA, INC.
Remove the shift lever assembly (A).
Tightening torque:

8.8 ~ 13.7 N.m(0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

Fig 5: Locating Shift Lever Assembly
Courtesy of KIA MOTORS AMERICA, INC.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.