2017 Kia Sedona EXFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

Information 

The oil temperature sensor is integrated with the solenoid valve main connector and can not be disassembled. The oil temperature sensor should be replaced with the solenoid valve main connector.

  1. Move the shift lever to "N" range.
  2. Remove the valve body assembly.

    (Refer to Hydraulic System - "VALVE BODY ")

  3. Disconnect the input & output speed sensor connector (A).
  4. Loosen the solenoid valve harness bolts (B).

    Tightening torque: 

    9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

    Fig 1: Locating Input & Output Speed Sensor Connector And Solenoid Valve Harness Bolts
    G12274715Courtesy of KIA MOTORS AMERICA, INC.
  5. Disconnect the solenoid valve connector (A).
    Fig 2: Disconnecting Solenoid Valve Connector
    G12274716Courtesy of KIA MOTORS AMERICA, INC.
  6. Remove the clip (A) and then remove the connector by pressing it downward.

    Tightening torque: 

    9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

    Fig 3: Pressing Connector
    G12274717Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.