Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Kia Sedona EXFACTORY OEM SERVICE PROCEDURE
Connector Pin Information
| No. | Connector A | No. | Connector B |
|---|---|---|---|
| 1 | GND | 1 | Driver mirror horizontal_output |
| 2 | Mirror sensor GND_output | 2 | Driver mirror vertical_output |
| 3 | Driver unlock state_Input | 3 | Mirror folding_output |
| 4 | Driver key lock switch_input | 4 | Mirror unfolding_output |
| 5 | Driver key unlock switch_input | 5 | Driver door unlock_output |
| 6 | SET switch_input | 6 | Driver door lock_output |
| 7 | IMS switch1_input | 7 | Battery (+) mirror control |
| 8 | IMS switch2_input | 8 | - |
| 9 | Body-CAN (High) | 9 | GND Power |
| 10 | Body-CAN (Low) | 10 | Mirror common_output |
| 11 | Mirror sensor power_output | 11 | Driver mirror heater_output |
| 12 | - | 12 | Battery (+) |
| 13 | Driver door open switch_input | 13 | IGN1 |
| 14 | Rear driver auto_output (Safety) | 14 | Mirror horizontal sensor_input |
| 15 | Rear driver window (Down)_output (Safety) | 15 | Mirror vertical sensor_input |
| 16 | Rear driver window (Up)_output (Safety) | 16 | Battery (+) power |
| 17 | Window lock_output | 17 | Front driver window (Up)_output |
| 18 | Front driver auto_output (Safety) | 18 | Front driver window (Down)_output |
| 19 | Front driver window (Down)_output (Safety) | ||
| 20 | Front driver window (Up)_output (Safety) | ||
| 21 | Safety power window enable_output | ||
| 22 | Tail lamp_output | ||
| 23 | Pocket lamp_output | ||
| 24 | Window lock_output 2 | ||
| 25 | Front assist window (Up)_output (Safety) | ||
| 26 | Front assist window (Down)_output (Safety) | ||
| 27 | Front assist auto_output (Safety) | ||
| 28 | Rear assist window (Up)_output (Safety) | ||
| 29 | Rear assist window (Down)_output (Safety) | ||
| 30 | Rear assist auto_output (Safety) | ||
| 31 | - | ||
| 32 | - |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.