Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Adjusting Procedure For Lock Cam And Shift Lock Cable
2017 Kia Rio EX, 4D HatchbackSECTION Adjusting Procedure For Lock Cam And Shift Lock Cable
- Shift lock cable must be fixed to brake pedal (brake pedal must not be pressed down), and at lever (shift lever) must be "N" position
- Shift lock cable must be assembled to at lever (shift lever) assembly as shown in illustration Fig 1 cable end must be inserted into fixing pin (A) of lock cam securely.
- Maintain close adhesion lock cam (E) and lock cam stopper (D) slightly pull outer casing of shift lock cable (E) in direction "E" to remove slack of shift lock cable (E).
- After checking that cable end is touched to cable fixing pin of lock cam, fix adjust plate.
- Check that cable end (B) is touched to cable fixing pin of lock cam (A).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.