Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2017RIO EX, 4D HATCHBACKREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSPOWER WINDOWSPOWER WINDOW SWITCHREPAIR PROCEDURESINSPECTIONREAR POWER WINDOW SWITCH INSPECTION
2017 Kia Rio EX, 4D Hatchback
Rear Power Window Switch Inspection
2017 Kia Rio EX, 4D HatchbackSECTION Rear Power Window Switch Inspection
- Disconnect the Negative (-) Battery Terminal.
- Remove the Rear Door Trim Panel.
(Refer to "REAR DOOR TRIM REPLACEMENT ")
- Disconnect the 8P connector from the switch.
- Check for continuity between the terminals in each switch position according to the table. If the continuity condition is not normal, replace the switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.