Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2017RIO EX, 4D HATCHBACKREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM DIAGNOSIS (2 OF 3)DTC P0335: CRANKSHAFT POSITION SENSOR 'A' CIRCUITW/HARNESS INSPECTIONGROUND CIRCUIT INSPECTION
2017 Kia Rio EX, 4D Hatchback
Ground Circuit Inspection
2017 Kia Rio EX, 4D HatchbackSECTION Ground Circuit Inspection
■ Check Open in Ground Circuit
- IG KEY "OFF".
- Disconnect CKPS connector.
- IG KEY "ON"
- Measure the voltage between signal terminal of CMPS harness connector and chassis ground. (A)
- Measure the voltage between signal and ground terminal of CMPS harness connector and chassis ground. (B)
Specification: "A" - "B" = Below 200mV
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.