Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Kia Optima Plug-In Hybrid EXFACTORY OEM SERVICE PROCEDURE
Engine Compression Test
- Warm up the engine to normal operating temperature.
- Remove the fuel pump fuse (15A).
- Wait until the engine stopped.
- Remove the ignition coils and spark plugs.
- Crank the engine to remove any foreign material in the cylinders.
- Put a compression pressure gauge into spark plug hole.
- Check compression pressure at each cylinder.
Specification :
Compression pressure: 980.6kPa (10.0kgf/cm2 , 142.2psi)/200 to 250 RPM
Minimum pressure: 833.5kPa (8.5kgf/cm2, 120.8psi)
Difference between each cylinder: 100kPa (1.0kgf/cm2, 15psi) or less
- Is compression pressure for each cylinder displayed within specifications?
YES
- Verify if the engine has excessive coolant consumption. If yes, check for damaged inlet water passage, engine block, cylinder head or head gasket. Repair or replace as necessary and go to "Verification of Vehicle Repair " procedure.
NO
- If the cylinder compression in 1 or more cylinders is low, pour a small amount of engine oil into the cylinder through the spark plug hole and repeat compression test for cylinders with low compression pressure.
- If adding oil helps the compression, it is likely that the piston rings and/or cylinder bore are worn or damaged.
- If pressure stays low, a valve may be sticking or seating is improper, or there may be leakage past the gasket. Repair or replace as necessary and go to "Verification of Vehicle Repair " procedure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
