2017 Kia Niro EXFACTORY OEM SERVICE PROCEDURE

Monitor DTC Status

Inspection Condition Inspection Procedure Reference
  1. Ignition "ON".
  1. Connect KDS/GDS to Data Link Connector(DLC).
  2. Monitor "Diagnostic Trouble Codes (DTC)" with KDS/GDS.
Fig 1
Fig 1: Screen Display - DTC Description
G12330234Courtesy of KIA MOTORS AMERICA, INC.
Active Fault 
History/Pending Fault 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.