2017 Kia Niro EXFACTORY OEM SERVICE PROCEDURE

Verification Of Vehicle Repair

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect KDS/GDS to Data Link Connector (DLC), and monitor "Diagnostic Trouble Codes (DTC)".
  2. Clear all DTCs in the system with KDS/GDS.
  3. Operate system or vehicle within DTC detecting condition in DTC Detecting Condition chart.
  4. Monitor "Diagnostic Trouble Codes (DTC)" with KDS/GDS and verify that any DTC is stored.
  5. Verify that the DTC is cleared and system operates correctly.
Good 
  • Problem is corrected and the system operation performs to specification at this time.
No Good 
  • Go to applicable troubleshooting procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.