2017 Kia Niro EXFACTORY OEM SERVICE PROCEDURE

Assist Power Window Switch

  1. Disconnect the negative (-) battery terminal.
  2. Remove the assist front door trim.

    (Refer to Body - "FRONT DOOR TRIM ")

  3. Disconnect the power window switch connector from the door trim.
    Fig 1: Assist Power Window Switch Connector
    G12335005Courtesy of KIA MOTORS AMERICA, INC.
  4. Check for continuity between the terminals in each switch position as displayed below.

[Power Window Switch Inspection]Β 

Fig 2: Power Window Switch Inspection Terminal Continuity Chart
G12335006Courtesy of KIA MOTORS AMERICA, INC.

[Power Door Lock Switch Inspection]Β 

Fig 3: Power Door Lock Switch Inspection Terminal Continuity Chart
G12335007Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.