2017 Kia Forte Koup EX, Standard TransFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Inspection

WARNING: This page is about a different car, the 2017 Kia Niro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check for resistance between terminals in each switch position (LH).
    Fig 1: Inspecting Resistance Between Terminals In Each Switch Position (LH)
    G12332287Courtesy of KIA MOTORS AMERICA, INC.

    [LH: Audio + Hands Free + Voice] 

    Switch Connector Terminal Resistance (±3%)
    SEEK Up 1-6 430 Ω
    SEEK Down 1.11 kΩ
    MODE 2.11 kΩ
    MUTE 3.11 kΩ
    Volume (+) 4.61 kΩ
    Volume (-) 6.81 kΩ
    Voice 10.71 kΩ
    END 18.91 kΩ
    SEND 40.91 kΩ
  2. Check for resistance between terminals in each switch position (RH).
Fig 2: Inspecting Resistance Between Terminals In Each Switch Position (RH)
G12332288Courtesy of KIA MOTORS AMERICA, INC.

[RH: Cruise + Trip] 

Switch Connector Terminal Resistance (±5%)
Cancel 2-6 390 Ω
SET - 610 Ω
RES + 910 Ω
Cruise ON/OFF 1.38 kΩ
Cruise & Speed Limit ON/OFF 2.13 kΩ
SCC (Following distance control) 3.63 kΩ
Group 1-6 390 Ω
Trip Up 610 Ω
Trip Down 910 Ω
ENTER 1.38 kΩ
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.