2017 Kia Forte EXFACTORY OEM SERVICE PROCEDURE

Liftgate Antenna

WARNING: This page is about a different car, the 2017 Kia Niro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative (-) battery terminal.
  2. Remove the rear transverse trim.

    (Refer To Body - "Rear Transverse Trim")Β 

  3. Remove the liftgate antenna (A) after loosening the mounting nuts and disconnecting the connector.
Fig 1: Removing Liftgate Antenna Mounting Nuts
G12335144Courtesy of KIA MOTORS AMERICA, INC.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.