Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2017 Kia Forte EXFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

Disconnect the negative (-) battery terminal.
Remove the heater & A/C control unit.
(Refer to Heating, Ventilation, Air Conditioning - "HEATER & A/C CONTROLLER UNIT (MANUAL) )

(Refer to Heating, Ventilation, Air Conditioning - "HEATER & A/C CONTROLLER UNIT (DATC ))
Remove the floor console assembly.
Remove the center lower cover (A) after loosening the screws.

Fig 1: Locating Center Lower Cover With Screws
Courtesy of KIA MOTORS AMERICA, INC.
Remove the BCM unit. (in the order as below)
1. Disconnect the connectors (A) from the BCM unit.
2. Loosen the mounting nuts (B).
3. Remove the BCM unit (D) after disconnecting the connector (C) from the BCM unit.

Fig 2: Locating BCM Unit, Connectors And Mounting Nuts

Courtesy of KIA MOTORS AMERICA, INC.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.