2017 Kia Cadenza TechnologyFACTORY OEM SERVICE PROCEDURE

EPB Not Applied

Fig 1: Electronic Stability Program System Connector End View (EPB Not Applied)
G12294509Courtesy of KIA MOTORS AMERICA, INC.
Pin No Description Current (amps) Resistance (mΩ) Remark
1 POS. BATTERY 2.(MOTOR) 137 (RUSH) 10  
2 C-CAN Low 30 mA 250  
13 PUMP MOTOR GROUND 137 (RUSH) 10  
14 C-CAN High 30 mA 250  
16 BRAKE LIGHT SWITCH 10 mA 250  
17 SENSOR FRONT RIGHT OUTPUT 16mA 250  
18 SENSOR FRONT RIGHT POWER 30 mA 250  
19 SENSOR REAR RIGHT POWER 30 mA 250  
20 SENSOR REAR LEFT SIGNAL 16.8 mA 250  
21 SENSOR FRONT LEFT SIGNAL 16.8 mA 250  
22 L-CAN High 30 mA 250  
23 ESP OFF SWITCH 10 mA 250  
25 POS. BATTERY 1.(SOLENOID) 40 10  
28 SENSOR REAR RIGHT OUTPUT 16 mA 250  
29 IGN1 (+) 50 mA 60  
30 DBC SWITCH 10 mA 250  
31 SENSOR FRONT RIGHT SIGNAL 16.8 mA 250  
32 SENSOR REAR RIGHT SIGNAL 16.8 mA 250  
33 SENSOR REAR LEFT POWER 30 mA 250  
34 SENSOR FRONT LEFT POWER 30 mA 250  
35 L-CAN Low 30 mA 250  
37 CLUTCH SWITCH 10 mA 250  
38 GROUND 40 10  
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.