Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Kia Soul Base, Automatic TransFACTORY OEM SERVICE PROCEDURE
Repair Procedures: Removal
- Change the shift lever to "N" range.
- Remove the valve body assembly.
(Refer to "VALVE BODY .")
- Disconnect the input & output speed sensor connector (A).
- Loosen the main connector bolt (B).
Tightening torque:Β
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
- Disconnect the solenoid valve connector (A).
- Remove the solenoid valve connector clip (B) after loosening a bolt and then remove the connector by pushing down to it.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
