2016 Kia Soul Base, Automatic TransFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Installation

  1. Install in the reverse order of removal.
    NOTE: The existing valve body cover gasket (A) must be replaced with a new one. (Do not reuse it.)
    G11952542Courtesy of
  2. Perform the procedures below after installing.
    1. Refill the automatic transaxle with fluid.

      (Refer to "FLUID .")

    2. Clear the diagnostic trouble codes (DTC) using the KDS/GDS. Disconnecting the battery negative terminal will not clear the DTCs. Clear DTCs using the KDS/GDS at all times.
    3. Reset the automatic transaxle adaptive values using the KDS/GDS.
      G11952543Courtesy of
    4. Perform the TCM adaptive values learning procedure.

      (Refer to "ADJUSTMENTΒ .")

    5. After installing, check for leakage of coolant or fluid from hose connection during engine start.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.