2016 Kia Soul Base, Automatic TransFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Place the shift lever into the "N" position.
  2. Disconnect the battery negative (-) cable.
  3. Remove the air cleaner.

    (Refer to "AIR CLEANER .")

  4. Disconnect the inhibitor switch connector (A).
  5. Remove the shift cable mounting nut (B).
    G11952591Courtesy of
  6. Remove the manual control lever (B) and the washer after removing a nut (A).
    G11952592Courtesy of
  7. Remove the inhibitor switch (A) after removing the bolts (2 ea).
    G11952593Courtesy of
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.