Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Kia Soul Base, Automatic TransFACTORY OEM SERVICE PROCEDURE
Electronic Stability Control (ESC) System
- Components And Components Location
- Description And Operation
- Schematic Diagrams
- Troubleshooting
- Failure Diagnosis
- ABS Does Not Operate
- ABS Does Not Operate (Intermittently).
- Communication With GDS Is Not Possible. (Communication With Any System Is Not Possible)
- Communication with GDS Is Not Possible. (Communication With ABS only Is Not Possible)
- When Ignition Key is Turned ON (Engine OFF), The ABS Warning Lamp Does Not Light Up
- Even After The Engine Is Started, The ABS Warning Lamp Remains ON.
- EBD (Electronic Brake - Force Distribution)
- ESC Control Module
- Front Wheel Speed Sensor
- Rear Wheel Speed Sensor
- Yaw - Rate And G Sensor
- ESC OFF Switch
- Steering Angle Sensor
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.