2016 Kia Soul !FACTORY OEM SERVICE PROCEDURE

Repair Procedures: Installation

  1. Check that the shift lever is placed in the "N" position.
  2. Install the shift cable retainer (A).

    Tightening torque: 

    11.8 - 14.7 N.m (1.2 - 1.5 kgf.m, 8.7 - 10.8 lb.ft)

    G11955946Courtesy of
  3. Install the shift cable (A).
    G11955947Courtesy of
  4. Install the floor console assembly.

    (Refer to "FLOOR CONSOLE .")

  5. Install the knob (A) by pressing it in the direction of arrow after installing the boots to the console upper cover.
    G11955948Courtesy of
  6. Install the shift cable (A) to bracket and then lightly tighten the nut (B).
    G11955949Courtesy of
    NOTE: The existing shift cable clip (A) must be replaced with new one. (Do not reuse it.)
    G11955950Courtesy of
  7. Tighten the nut (A) to the specified torque after removing free play by pushing the shift cable in the direction of the arrow.
    G11955951Courtesy of
  8. Install the battery and battery tray.

    (Refer to "BATTERY .")

  9. Install the air cleaner assembly.

    (Refer to "AIR CLEANER .")

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.