Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2016 Kia Sorento LFACTORY OEM SERVICE PROCEDURE

Repair Procedure: Removal

Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
Lift the vehicle.
Disconnect the canister close valve connector (A).
Disconnect the ventilation tube quick-connector (B) from the fuel tank air filter and canister close valve.

Fig 1: Disconnect Canister Close Valve Connector
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the vapor tube quick-connector (A).
Remove the canister assembly bracket (D) after removing the mounting bolts (B) and nut (C).

Fig 2: Remove Canister Assembly Bracket Mounting Bolts And Nut
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the CCV Connector (A).

Fig 3: Disconnect CCV Connector
Courtesy of KIA MOTORS AMERICA, INC.
Remove the fuel tank air filter & canister close valve assembly (A) after rotating it in the direction of the arrow in the figure.

Fig 4: Locate Fuel Tank Air Filter
Courtesy of KIA MOTORS AMERICA, INC.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.