Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Limp Home Mode
- When brake input is not received (AT specification)
Moves to the "START" when SSB is pressed longer than 10 seconds in ACC state.
- In case of communication problem between EMS and CAN (In other words, EMS state cannot be determined.), moves to the state of "ENGINE RUN" from "START" based on the RPM input.
- In case of short out of two SSB input lines
The electric power cycling is available when SSB is pressed twice within 10 seconds (SSB LIMP HOME PRESS)
The buzzer sounds when the button is pressed for the first time.
The electric power cycling is available and buzzer stops when the button is pressed twice within 10 seconds.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
