2016 Kia Sedona LFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

NOTE: Note that the SST (Part No: 09392-1Y100 or 09392-2H100) is used when removing the heated oxygen sensor.

[Bank 1/Sensor 1] 

  1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
  2. Disconnect the connector (A).
    Fig 1: Locating Connector - Bank 1/Sensor 1
    G11856667Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the heated oxygen sensor (A).
Fig 2: Locating Heated Oxygen Sensor - Bank 1/Sensor 1
G11856668Courtesy of KIA MOTORS AMERICA, INC.

[Bank 1/Sensor 2] 

  1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
  2. Disconnect the connector (A).
    Fig 3: Locating Connector - Bank 1/Sensor 2
    G11856669Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the heated oxygen sensor (A).
Fig 4: Locating Heated Oxygen Sensor - Bank 1/Sensor 2
G11856670Courtesy of KIA MOTORS AMERICA, INC.

[Bank 2/Sensor 1] 

  1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
  2. Disconnect the connector (A).
    Fig 5: Locating Connector - Bank 2/Sensor 1
    G11856671Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the heated oxygen sensor (A).
Fig 6: Locating Heated Oxygen Sensor - Bank 2/Sensor 1
G11856672Courtesy of KIA MOTORS AMERICA, INC.

[Bank 2/Sensor 2] 

  1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
  2. Disconnect the connector (A).
  3. Remove the heated oxygen sensor (B).
Fig 7: Locating Heated Oxygen Sensor And Connector - Bank 2/Sensor 2
G11856673Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.