2016 Kia Sedona EXFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Inspection: Notes

WARNING: This page is about a different car, the 2016 Kia K900. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check for resistance between terminals in each switch position.
    Fig 1: Steering Wheel Remote Controller Connector Terminals (LH Top)
    G11803895Courtesy of KIA MOTORS AMERICA, INC.

    [LH Top (Audio)] 

    Switch Connector Terminal Resistance (± 5%)
    Seek Up 1-3 240 Ω
    Mode 510 Ω
    Volume Up 940 Ω
    Seek Down 1.69 kΩ
    Volume Down 3.29 kΩ
  2. Check for resistance between terminals in each switch position.
    Fig 2: Steering Wheel Remote Controller Connector Terminals (LH Bottom)
    G11803896Courtesy of KIA MOTORS AMERICA, INC.

    [LH Bottom (B/T+LDWS+Heated ST)] 

    Switch Connector Terminal Resistance (± 5%)
    LDWS 3-4 240 Ω
    Send 510 Ω
    Mute 940 Ω
    Voice 1.69 kΩ
    End 3.29 kΩ
  3. Check for resistance between terminals in each switch position.
    Fig 3: Steering Wheel Remote Controller Connector Terminals (RH Bottom)
    G11803897Courtesy of KIA MOTORS AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.